Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - nimon

#1
Support / Re: cutting with disk cutter tool
May 24, 2017, 01:32:26 PM
Thanks for the reply.
I've tried to deconstruct the frame and construct it by replacing Z to Y vectors, but I still receive a rotation about X axis.
I've two tools on simulation, one has 90 degree rotation and it seems visually that the above method is working on the one without rotation.
#2
Support / cutting with disk cutter tool
May 20, 2017, 06:48:48 AM
Hi,
I'm trying to cut a some sluts on a hemisphere surface using projected curves and Evaluating Surface to generate frames normal to the surface. The problem is since the cutting disk should be always parallel to the X axis in order to cut a straight line that I cant achieve using above method. Is the any trick to limit tool's rotation in one of orientation axis (lets say A or C)?