thank you very much the problem is solved ;D
in this case I cannot simulate the opening and closing of the gripper ::)
in this case I cannot simulate the opening and closing of the gripper ::)
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Support / Digital Output - KUKA | prc
June 11, 2021, 02:07:49 AM
Hello :)
when I use the command "Digital Output - KUKA | prc" in DynamoStudio, an error message is displayed "Warning: Logic.RunCORE operation failed" :'( :'(.
is there a problem in Kuka :o ? What is the solution :-[?
when I use the command "Digital Output - KUKA | prc" in DynamoStudio, an error message is displayed "Warning: Logic.RunCORE operation failed" :'( :'(.
is there a problem in Kuka :o ? What is the solution :-[?
#3
Support / Custom tools for kuka PRC for Dynamo
May 14, 2021, 11:43:17 PM
Hello :)
Please, where can i download the custom tools for kuka PRC for Dynamo (gripper)? :-\
Please, where can i download the custom tools for kuka PRC for Dynamo (gripper)? :-\
Pages1