Hi,
Quick question about the start position. I saw another thread about programmatic start positions, although I didnt quite understand the implementation, or if it was ever fully released.
In hotwire foam cutting, i'd like to start the bot at the first point every time. Currently, I will send the robot to that point in the simulation, then get that position as start in the settings. We are cutting large blocks, and it's easiest for us to use the wire to align the block to. This position changes nearly every time. I'm wondering if there is a way I can delete the step to set the start point in settings and just set it programmatically. This will help reduce user errors by forgetting to set the start, or if the old point is close to the new point and you just dont notice.
Thanks!
Quick question about the start position. I saw another thread about programmatic start positions, although I didnt quite understand the implementation, or if it was ever fully released.
In hotwire foam cutting, i'd like to start the bot at the first point every time. Currently, I will send the robot to that point in the simulation, then get that position as start in the settings. We are cutting large blocks, and it's easiest for us to use the wire to align the block to. This position changes nearly every time. I'm wondering if there is a way I can delete the step to set the start point in settings and just set it programmatically. This will help reduce user errors by forgetting to set the start, or if the old point is close to the new point and you just dont notice.
Thanks!