Print Page - Some Kuka|prc settings not saved in .gh

Title: Some Kuka|prc settings not saved in .gh
Post by: antl on June 29, 2018, 09:05:00 AM

Hi Johannes,

I wanted to report you a bug: some Kuka|prc settings not saved in the .gh file.
For example, the status of "Simulate Without KRL Generation" or the "PTP acceleration" value.

This can be annoying, especially for the status of "Simulate Without KRL Generation" since I run multiple simulation in
a single gh file, then I am not garanteed that the right KRL code is generated.

My Kuka|prc version is 2018-04-27.

Best regards,
Antoine LUCAT

Title: Re: Some Kuka|prc settings not saved in .gh
Post by: Johannes @ Robots in Architecture on June 29, 2018, 11:40:04 AM

Hello Antoine,

Thanks a lot for letting me know, I have just fixed that issue, I'll try to upload a new version today!

Best,
Johannes

Title: Re: Some Kuka|prc settings not saved in .gh
Post by: antl on June 29, 2018, 02:39:56 PM

Thank you for your consideraton :)

Antoine

Title: Re: Some Kuka|prc settings not saved in .gh
Post by: Johannes @ Robots in Architecture on June 29, 2018, 07:08:02 PM

Hello,

Please take a look at today's release, it should now properly save those values.

Best,
Johannes

Robots in Architecture Forum

KUKA|prc - parametric robot control for Grasshopper => Support => Topic started by: antl on June 29, 2018, 09:05:00 AM