Quote from: Johannes @ Robots in Architecture on September 14, 2014, 10:12:33 AMThank you for this infrormation . I am new in the field , it is good to know the different manipulations .
Hello,
Well, the nice thing about Grasshopper is that you can implement your custom algorithms for e.g. importing G-code and turning 3 or 5-axis toolpaths into proper robot code.
At the moment, we have a component for SprutCAM, but a while ago we also worked on a postprocessor for VisualMill G-code (which should be similar to RhinoCAM). So it's definitely possible Mobilier pas cher. The first step would be to send me an exemplary G-code file. If you can choose from multiple internal postprocessors, choose the one that makes the least messy code. Then I'll be able to tell you if that is easy to do or not!
Best,
Johannes
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
General Discussion / Re: required software for milling with Kuka PRC
September 13, 2016, 01:55:37 PMPages1