Messages

Yes that looks way more convenient , thank you!!

are this the right pins for the X11 connector:
https://www.amazon.com/PC-Accessories-Connectors-Plated-Crimping/dp/B00EDFJFD6/ref=sr_1_2?crid=268GAM375577D&keywords=Pro+D-Sub+Male+Crimp+Pins&qid=1659372051&sprefix=pro+d-sub+male+crimp+pins%2Caps%2C53&sr=8-2%27

thank you!

Hello, I am getting a memory error when coping files as big as 4 MB, I already deleted most files that are not needed on the project. Is it possible to expand the memory or run a file from USB to be able to run larger files? I feel I am missing something as I have seen very large prints done that probably require many lines of code.

that remains to be seen.

Still having the same issue, I dont see any zero values in the code, it happens in the first command. Right after the start position, it goes to the first point and it stops there with the same error.

I will look into it , it happened with many of the tests I made so I am assuming its the Start Gcode setup, otherwise it would not make sense for the it to be zero, Ill test without the start gcode and get back here with the outcome.

Here is the src:

Couple years latter lol, but Im still getting that problem here is the SRC file.

I can also send you the gcode , rhino and gh file.