Hey Guys!
I was fortunate enough to have the chance to visit Johannes at his Creative Robotics lab late last year and filmed a couple tutorial videos and have finally found the time to record and upload the first one - an introduction to setting up 5 axis milling with KUKA prc. You can find it here:
https://youtu.be/BvgKW-CPLTg (https://youtu.be/BvgKW-CPLTg)
Hope some of you find it helpful!
Can you explain and guide how to export Gcode/NC file to load into Robot?
Hello,
I cannot comment on Karl's video, but in general you would get 5-axis G-code e.g. from our customized postprocessor in Fusion and then use the provided GH component to import the G-code and to set some parameters to turn it into 6-axis robot code that can run on the robot.
Note that those components are only available to users with a valid membership or license!
Best,
Johannes