Robots in Architecture Forum

Robots in Architecture, Art, and Design => General Discussion => Topic started by: limitednaja02 on September 02, 2019, 12:27:59 PM

Title: Pulsing with Robot
Post by: limitednaja02 on September 02, 2019, 12:27:59 PM
Hi there,I'm balloon
I am recently new to working with Kuka PRC. I am wanting to weld with the robot and was wondering how I could pulse with the robot. I am hoping to extrude the weld and create an object, so I am assuming I need to figure out how to make the robot pulse. Any ideas would be helpful. Thanks!

เว็บแทงบอล (https://www.ufa700.com/)
Title: Re: Pulsing with Robot
Post by: Johannes @ Robots in Architecture on September 02, 2019, 05:35:14 PM
Hello,

I'm not a welding expert, but you can use the regular KUKA PULSE command that works like that: PULSE($OUT
Just put it into a Custom KRL component, which you then place in the right order.

Best,
Johannes