Robots in Architecture Forum

KUKA|prc - parametric robot control for Grasshopper => Support => Topic started by: TayebBa on June 11, 2021, 02:07:49 AM

Title: Digital Output - KUKA | prc
Post by: TayebBa on June 11, 2021, 02:07:49 AM
Hello  :)
when I use the command "Digital Output - KUKA | prc" in DynamoStudio, an error message is displayed "Warning: Logic.RunCORE operation failed"  :'(  :'(.
is there a problem in Kuka  :o ? What is the solution   :-[?
Title: Re: Digital Output - KUKA | prc
Post by: Johannes @ Robots in Architecture on June 11, 2021, 08:20:12 AM
Have you tried not setting a value for the TOOL input?

Best,
Johannes
Title: Re: Digital Output - KUKA | prc
Post by: TayebBa on June 11, 2021, 07:33:51 PM
thank you very much the problem is solved  ;D
in this case I cannot simulate the opening and closing of the gripper  ::)