Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - mcb

#1
Did you solve the large measurement error during calibration? This could also be due to an incorrect gear ratio being set. Do you have the exact ratio for your gearbox?
#2
We had this error also "Kinematic instruction inadmissible".. there was a setting in: Setup-> Service-> Config External Axis that we had missed, or you can edit the R1\MADA\$machine.dat file directly.


$EX_KIN should have ET 1 set to EASYS
$ET1_AX should have TR_A1 set to E1 , name of transformation can be whatever e.g"turntable"
$ET1_TPINFL should have the x value set to the distance from the centre of the turntable to your reference mark.

hope it helps..
#3
General Discussion / fusion 360 multi axis 'flow'
January 27, 2018, 01:09:06 AM
Hi Johannes,
Do you know if the Fusion multi axis 'flow' feature will work with the prc-fusion post processor?
It looks very useful!

Matt