Hi,
I've been following your tutorials and think they're great. I successfully followed the draw/engrave tutorial and was able to replicate what you had done and then change the parameters to suit the robot I am working with (KR6 r900). However when I follow this tutorial (pick and place prt 1) my simulation robot does not generate and I can't test/simulate the script. I have tested to ensure the prc is still working in the grasshopper document from the drawing tutorial and it is.
I am new to grasshopper though I could be missing something.
Any ideas why this might be happening and how to troubleshoot?
I'm using Rhino 6 and KUKA|prc (TRIAL)
Any help you can give with this would be much appreciated.
Thanks
I've been following your tutorials and think they're great. I successfully followed the draw/engrave tutorial and was able to replicate what you had done and then change the parameters to suit the robot I am working with (KR6 r900). However when I follow this tutorial (pick and place prt 1) my simulation robot does not generate and I can't test/simulate the script. I have tested to ensure the prc is still working in the grasshopper document from the drawing tutorial and it is.
I am new to grasshopper though I could be missing something.
Any ideas why this might be happening and how to troubleshoot?
I'm using Rhino 6 and KUKA|prc (TRIAL)
Any help you can give with this would be much appreciated.
Thanks