Hello amazing set up!
I had a couple of questions about it:
Did you integrate it yourself or who did?
Are you using KukaCnc or CamRob or something else to run the Powermill files?
What's the spindle and what are you milling?
In general how's it going. It is, as Johannes mentioned, a very impressive set up!
I had a couple of questions about it:
Did you integrate it yourself or who did?
Are you using KukaCnc or CamRob or something else to run the Powermill files?
What's the spindle and what are you milling?
In general how's it going. It is, as Johannes mentioned, a very impressive set up!