This is for the Kuka KRC4 interface without a Beckhoff 1100.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Support / Re: KR10 X11 Diagram
June 24, 2019, 10:47:26 PM
We don't have a Beckhoff 1100 - this is the Kuka interface. We will make another post of how we did this.
#3
Support / Error during ECat stack initialization?
June 08, 2019, 12:14:32 AM
KSS13012 "<SYS-X44> Error during ECat stack initialization [NetworkResponse () no Network Response]"
(Nothing is plugged into X65 (EtherCAT)
It seems to be otherwise working... can I ignore this error or does it need to be fixed?
(Nothing is plugged into X65 (EtherCAT)
It seems to be otherwise working... can I ignore this error or does it need to be fixed?
#4
Support / Re: KR10 X11 Diagram
June 07, 2019, 08:34:14 PM
Thanks Johannes!
Battery plugged in, mastering completed, X11 plug built, now onto the Beckhoff EK1100 coupler.
Attached is a noted PDF of the process of constructing the X11 bypass plug...
Battery plugged in, mastering completed, X11 plug built, now onto the Beckhoff EK1100 coupler.
Attached is a noted PDF of the process of constructing the X11 bypass plug...
#5
Support / Re: KR10 X11 Diagram
June 05, 2019, 07:49:00 PM
Going to try to master them on Friday - so we will see if its all working then!
#6
Support / KR10 X11 Diagram
June 04, 2019, 11:52:43 PM
Working on bypassing X11 on our two new KR10s - attached is a diagram we've put together from all of the sources / information we've received.
Pages1