Messages

Thanks for your reply

About the document you mentioned, could you please provide a PDF file?

Or do you have any ideas to make the ptp or line movement a little smoother?

Best wishes

It looks like the file didn't upload properly, so I'll upload it again.

Hi there,

I'm using MXA for 3D printing.And I'm having some problems.To make printing smooth, i use spl commend,but it not work.

You can see in first image that MXA runs the first 9 lines of commands fine, but when it gets to the 10th line of the spl command, it looks like he skipped that command and didn't run it, and went straight to the 11th line of the command.

I simulated the same commands with kukaprc without problems, and I also had no problems running the program offline on the robot.

And in the src file, I found that the spl command seems to be a spl block which contains all the spl commands, so I wonder if it's because max can't read the commands in the spl block.I wonder if you have any way to unblock spl commend in grasshopper.

My prc version is 2023-07-24 and mxa version is 3.0.3

These are the files that I have used. I would appreciate a reply from you.