Thanks Johannes. It was due to the .NET framework not being installed. For the record, I am on Windows 7.
Feel free to close the thread.
Feel free to close the thread.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Support / KUKA|prc 2 crash when opening KUKA|prc CORE settings
October 01, 2015, 07:11:10 AM
Steps to reproduce:
1. Open Rhino.
2. Open Grasshopper.
3. Create a new KUKA|prc core module. (for KUKA|prc2)
4. Right click module -> Open KUKA|prc Settings
Behavior:
1. Rhino and Grasshopper crashes and quits.
Expected behavior:
1. No crash.
I suspect this is a local issue, as otherwise it's a pretty major bug. KUKA|prc version is KUKAprcNEWsetup_2015_09_27. License is for University of Sydney. How can I get a better error log to debug this issue? Alternatively, is there another way I can access those settings without going through the Grasshopper interface?
Thanks,
1. Open Rhino.
2. Open Grasshopper.
3. Create a new KUKA|prc core module. (for KUKA|prc2)
4. Right click module -> Open KUKA|prc Settings
Behavior:
1. Rhino and Grasshopper crashes and quits.
Expected behavior:
1. No crash.
I suspect this is a local issue, as otherwise it's a pretty major bug. KUKA|prc version is KUKAprcNEWsetup_2015_09_27. License is for University of Sydney. How can I get a better error log to debug this issue? Alternatively, is there another way I can access those settings without going through the Grasshopper interface?
Thanks,
Pages1