Messages

Hello Johannes,
I uploaded a video. You may check the attachement.
In the video you can see there is an error messge but just show about 0.2 second in smartPAD.
KSS00108 Dynamic Braking Active

Regards,
Ming

This problem is not happening with the KUKA test program. I use the desktop computer with high performance power option. Thanks.

There is a problem when using mxA. If there is no operation or command after one or two minutes, update the new command will not take effect until RESET mxA. The error message shows "The $PRO_ACT singnal of the Automatic External interface is not active" as the below screenshot. Is there any solution? Thanks.