Hi Johanne
I am having this A04 member issue as well. My grasshopper/Kukaprc simulation do not show that the a4 member will flip 180 degrees going from start position to the work piece. Same issue shown in the video of this thread. Are there any other tricks to fix this other than trying different start positions?
Thanks
Joanne
I am having this A04 member issue as well. My grasshopper/Kukaprc simulation do not show that the a4 member will flip 180 degrees going from start position to the work piece. Same issue shown in the video of this thread. Are there any other tricks to fix this other than trying different start positions?
Thanks
Joanne