Great tip, big help, Thank you so much for your support.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Support / Re: Woven CMD not working
April 20, 2023, 10:59:47 PM
Hello Johannes and Karl,
I share the same question regarding the Command Weaver. Specifically, if I need to create a sequence of tool paths, such as machining two surfaces using a combination of LIN and PTP commands to maneuver the tool around the object, would the Command Weaver be suitable for this task even though the number of elements in each command differs? If not, how would be able to do so?
Kind regards,
Ali
I share the same question regarding the Command Weaver. Specifically, if I need to create a sequence of tool paths, such as machining two surfaces using a combination of LIN and PTP commands to maneuver the tool around the object, would the Command Weaver be suitable for this task even though the number of elements in each command differs? If not, how would be able to do so?
Kind regards,
Ali
Pages1