We are actually running KSS8.3.
I will look through these examples. Thank you for sharing!
I will look through these examples. Thank you for sharing!
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
General Discussion / Re: Streaming values to computer UDP or TCP KRC4
April 26, 2021, 10:42:38 PM #2
General Discussion / Re: Streaming values to computer UDP or TCP KRC4
April 26, 2021, 07:30:56 PMQuote from: Johannes @ Robots in Architecture on April 23, 2021, 10:39:43 PM
The "Ethernet" example in the DOC/Examples/Ethernet is useful for the configuration.
Hey Johannes,
I can't find the "Ethernet" example. Are there other examples than the ones on the Tutorials page?
#3
General Discussion / Re: Streaming values to computer UDP or TCP KRC4
April 26, 2021, 03:35:20 PM
Thanks, Johannes!
We are doing great here. I finally have a bit of free time to develop some features that have been left behind.
Thanks for the feedback about RSI. I will look into this more and let you know if I run into any issues.
I'll check out the examples as well.
Kind regards,
Jake
We are doing great here. I finally have a bit of free time to develop some features that have been left behind.
Thanks for the feedback about RSI. I will look into this more and let you know if I run into any issues.
I'll check out the examples as well.
Kind regards,
Jake
#4
General Discussion / Streaming values to computer UDP or TCP KRC4
April 23, 2021, 07:44:44 PM
Hello everyone,
I am interested in streaming values of user defined variables to a computer from the controller. I am looking into what packages might be required for KRC4 to achieve this.
I do not have EKI and would like to know if anyone here has experience with it. I have used very similar tech packages for Staubli and ABB with great success.
EKI seems to be the best option from the documentation I have seen, but I don't have a way of testing before purchasing.
I do have RSI, but I am not as interested in streaming motion parameters. Has anyone used RSI to stream values other than motion controls?
I also have KLI for RemoteView, but I don't see how I could get the values out of remote view.
If anyone has ideas or experience, I would appreciate your input. I am about to go down the rabbit hole of CRead and CWrite and wanted to check in to see if there is a better way forward.
Kind regards,
Jake
I am interested in streaming values of user defined variables to a computer from the controller. I am looking into what packages might be required for KRC4 to achieve this.
I do not have EKI and would like to know if anyone here has experience with it. I have used very similar tech packages for Staubli and ABB with great success.
EKI seems to be the best option from the documentation I have seen, but I don't have a way of testing before purchasing.
I do have RSI, but I am not as interested in streaming motion parameters. Has anyone used RSI to stream values other than motion controls?
I also have KLI for RemoteView, but I don't see how I could get the values out of remote view.
If anyone has ideas or experience, I would appreciate your input. I am about to go down the rabbit hole of CRead and CWrite and wanted to check in to see if there is a better way forward.
Kind regards,
Jake
Pages1