Hello, I am trying to use a KR120R2500 PRO to mill a slab of CLT, and I am having trouble with the toolpaths. When I run the simulation in grasshopper/rhino the tool seems to be moving in strange ways, as it will go different directions, pickup and move to different spots seemingly at random, and it will somtimes retrace the paths back up to the top layer and then start again. I have attempted a few ways of trying to fix this but havent yet found a solution. Hoping for any insight on how to fix the toolpaths to get it to move in a consistent direction, as well as get it to move down a z level directly after finishing the previous level. Thank you!