Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Cian

Tutorials / Re: Video Tutorial - Pick & Place Part 1
March 07, 2018, 03:24:31 PM

I've been following your tutorials and think they're great. I successfully followed the draw/engrave tutorial and was able to replicate what you had done and then change the parameters to suit the robot I am working with (KR6 r900). However when I follow this tutorial (pick and place prt 1) my simulation robot does not generate and I can't test/simulate the script. I have tested to ensure the prc is still working in the grasshopper document from the drawing tutorial and it is.
I am new to grasshopper though I could be missing something.
Any ideas why this might be happening and how to troubleshoot?
I'm using Rhino 6 and KUKA|prc (TRIAL)

Any help you can give with this would be much appreciated.