Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - fr1670

#1
Hello,

Thank you for the response. In spurt cam what post processors setting do you have to use for KUKA PRC?

Regards,
Nick
#2
Hello all,

I understand in the membership version you can take g-code from spurt cam and covert it to robot language. I am wondering if anyone has done this with master cam G-code and if so did you come across any issues?

Regards,
Nick   
#3
Hello,

Thank you for the updated milling files. The goal I am trying to reach is to have a single mill path go around the chamfer and fillet for all sides in one smooth continuous path. The tool I am using is a laser that is just needs to go long the normal of the surface of the chamfer and fillet one time. Just to give you a better idea of what I am trying to do with the KUKA.

Regards,
Nick
#4
General Discussion / Milling on Mutiple surfaces
June 29, 2018, 04:15:41 PM
Hello All,

I was wondering if anyone knew how to mill across multiple surfaces just using grasshopper programing and not using CAM software. Like in the picture below going across from the chamfer to the fillet in one smooth  mill path.

Regards
#5
General Discussion / KUKA Robot Choices
June 19, 2018, 05:42:24 PM

In grasshopper is the KR 150L150SP/2 the same as the KR 150-240 -2L130/230?