Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - pyw110001

#1
Dear Johannes,
thx for the reply. the KSS is 8.5.7 HF and MXA v3.0.3. I've tried many times but still can't get it to work. :'(
The error code is shown in the figure. In order to successfully run the DEMO program I set the $MOVE_ENABLE port to 2060, does that matter ?
Do I need to open any programs when under EXT mode?
#2
General Discussion / how to setup MXA module in PRC
July 09, 2020, 03:57:44 AM
hi,everyone, i'm having trouble with the setup.
The current situation is that i've installed MAX(3.0x,My KSS is 8.5) on the robot and the UPD_Server Example has been successfully run,but it didn't work in PRC.
I've disabled the firewall on the PC. I'm not sure if there is a problem with the MXA settings, can someone help me, do i need to set up Physical IP on Mxa Module,is that my PC IP address or somethingelse, and where can i get the Robot ID?