Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Abishek Golecha

#1
General Discussion / Re: Wait for Digital Input
September 26, 2019, 01:30:24 PM
Hallo Johannes,

Thank you for your reply. I used rotate 3-d plugin in grasshopper to align the plane along the required direction and angle. But I guess your solution would work as well. Will update any further details if required. Regards,

Abishek
#2
General Discussion / Re: Wait for Digital Input
September 23, 2019, 12:42:08 PM
Hallo Johannes,

Firstly, Thank You for your reply. I guess it is not possible to visualize the 'wait for digital input' command in grasshopper but would function properly in real time. As I am quite new to grasshopper and KUKA plugin, I do not have much idea about it. Is it possible to get a tutorial or a working manual where each option is explained in detail ?. If yes, that would be very helpful. Also, as mentioned in the earlier post, I am trying to pick up and assemble facade elements using multiple robots. If the elements are to be placed on the ground in XY plane, the pick and place algorithm is quite simple as guided by Karl Singline. But what if an element is not oriented along the XY plane ? I have to assemble Pipe 1 in between the horizontal and vertical pipes and I am unable to orient pipe 1 along the required 3-d axis. I tried using the axis movement to position the robot in a way that the element grabbed is of the same orientation as to where it should be placed. But the axis movement makes the robot orient the element in correct geometric direction but not at the required destination or point. I have attached my grasshopper file for furthe visulaization.

Regards,
Abishek
#3
General Discussion / Wait for Digital Input
September 20, 2019, 04:46:27 PM
Hallo everyone,

I am new to KUKA plugin and I am using the basic version KUKAplrc. I am trying to assemble a facade using multiple robots. The robots should not collide with each other during the assembly process. Since I do not have a member version, I am not able to use RoboTeam or check for collision. I want to basically pick up and place each item using different robots without them colliding with each other. I use robot 1 to pick up node1 and robot 2 to pick up Pipe Horizontal top (HT) and robot 3 to pick up Pipe Vertical Left (VL). My robots pick and place correctly but I want robot 2 and 3 to strat only after robot 1 has finished its task. I know I can use Wait for 'n' seconds command or alter the speeds of each robot but I was wondering about Wait for Digital Input command. Is it possible that I ask robot 2 and 3 to stop until a digital input is fed to them by robot 1 after robot 1 completes its task ?. I have attached a part of my grasshopper file for more details. Thanks in advance,

Regards,

Abishek