Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - HausBot

Support / Re: No Signal from Digital I/O
October 13, 2021, 10:42:00 PM
This worked, thanks for your help!
Support / No Signal from Digital I/O
October 11, 2021, 12:51:30 AM

I am having trouble using the digital outputs on our KR10 R900 sixx.
I'm trying to use the Digital Out command to ultimately control an extruder. A previous student informed me that the connector on the wrist of our robot has digital outputs 13 and 14. When I add the digital out commands in the code and set the state to TRUE, I can see the value of the digital outputs change to true on the controller (see picture).

However, I'm not getting any signal from the pins that correspond to these outputs. I do get 24 volts across the other pins I marked (see picture), so presumably the connector is hooked up correctly.

If anyone knows what I'm missing to actually get an output signal, please let me know.