Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Leo ongbo

Pages: [1]
1
Support / Re: How to add two external axis
« on: June 24, 2022, 03:32:50 AM »
Hi Johannes,

Thanks for your kindly help.

Best,
Hongbo

2
Support / Re: How to add two external axis
« on: June 22, 2022, 11:17:05 AM »
Dear Johannes,

I am still learnning C# with the Stuggart University wrokshop Recording in youtube.
I think I could do a bit of C#. And I can learn fast.
Really appreciate for your kindly help.

Best regards,
Hongbo

3
Support / Re: How to add two external axis
« on: June 22, 2022, 10:56:08 AM »
Dear Johannes,

I am sorry for the delay of reply.
yeap, I am using a custum two-axis positioner.
My achivement is when E01 turn around, the E02 turn 45 degree to help the print.
Addition, thanks for you remarks that really helpful !

Best regards,
Hongbo

4
Support / Re: How to add two external axis
« on: June 20, 2022, 03:36:38 AM »
Dear Johannes,

I have attached my gh and 3dm file on the below. I really appreciate for your kindly help.

Best regards,
Hongbo

5
Support / Re: How to add two external axis
« on: June 17, 2022, 05:26:55 AM »
Dear Johannes,

That's really inspired me. But I meet a new proble. As digarm shown, I give 2 axis here(Red line). But those tow turn panels just turn around Axis 01(Base on the vector). Could you give me any advice?

Best regards,
Hongbo

6
Support / How to add two external axis
« on: June 16, 2022, 08:12:27 AM »
Hello everyone,

I am a new user with KUKA prc. I want to use to axis same time for my tow-axis positioner.
in general, I studied the tutorial and the example to add Custom turntable. But I still do not know how to add one more horizontal axis order in KUKA PRC.
May I kindly asking for some help for the problem?

In addition, I just confuse about why I have change the E01 source to E02, but the src file still give the source to E01? ???

Pages: [1]