Topics

Hello,

Can somebody say if there is any way to define the attributes of the "src" file? I am mostly interested to write the "Comment" field (see the picture). I know you can define it during the creation of new program in SmartPad, but can I write it remotely, for example on  my PC?

best,
Mikail

Hi everybody, I need some help!

I am currently working with milling project and there is one problem that I cannot solve for a few months. I have no idea what this problem about. I am using KUKA robot for perform milling operation with foam and there are few bugs in outcome. When I am trying to mill the same surface (half sphere) for a few times the tool is not going through the same working level, that in turn leads to some notches and marks (or the tool just going upper the working surface).

During the troubleshooting the following parts were changed:
1. was changed/rebuild the rotation table,
2. was remastered the robot and recalibrated a tool,
3. were changed few tools,
4. were simulated different toolpaths with different angles, with different motions.

However, there is no clean surface in the result.
For simulation/code generation the Sprutcam  is used.

The few photos that describe this problem are attached.