Hi All,
Rather than using the divide surface component, I'm interested in milling the successive layers of foam prior to reaching my finish surface. I'd also like the robot to return to a "safe plane" between layers so that it doesn't plow through the material on its way to the next layer down. Has anyone achieved this in PRC? Attached is my attempt. I'm almost there, I just have a data issue where I need to repeat the portion (grouped in purple) for each slice (without copying it and pasting for every slice).
Thanks,
Rather than using the divide surface component, I'm interested in milling the successive layers of foam prior to reaching my finish surface. I'd also like the robot to return to a "safe plane" between layers so that it doesn't plow through the material on its way to the next layer down. Has anyone achieved this in PRC? Attached is my attempt. I'm almost there, I just have a data issue where I need to repeat the portion (grouped in purple) for each slice (without copying it and pasting for every slice).
Thanks,