There is a problem when using mxA. If there is no operation or command after one or two minutes, update the new command will not take effect until RESET mxA. The error message shows "The $PRO_ACT singnal of the Automatic External interface is not active" as the below screenshot. Is there any solution? Thanks.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
Support / mxA， The $PRO_ACT singnal of the Automatic External interface is not active
May 23, 2022, 02:00:23 PMPages1