Does anyone know how to convert a complex surface from Rhino to a toolpath with certain offsets, such as basically creating a fill pattern with a cutting path/sliced layers.
Bob
Bob
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Support / Adjusting Planes on each point
July 31, 2015, 10:17:35 PM
I'm creating a helical bent tube at 90deg(see pix). I want the yellow orientation lines to also follow the direction of the tube, basically make a gradual angle following the helix. I can't figure out how to adjust the planes of each point to do this. Anyone know? I'm using the simplepath.gh file for now to get me started.
Bob
Bob
Pages1