Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - ddzelajlija

Pages: [1]
1
General Discussion / Starting in WorkVisual
« on: November 03, 2015, 02:54:24 PM »
Hello everyone! :)

I am near the end of my studies at the Faculty of Electrical Engineering in Osijek, Croatia, and i got a job. My assignment in a Company is working with robotic hands.
In a couple of weeks i'll be going to Austria for a Kuka robot Training.
I want to be prepared as much as possible, so i started reading all the Kuka catalogs.
I contacted Kuka, and asked them to send me the software i'll need so i can be prepared.
They sent me WorkVisual, but i cannot find anything on the web that could help me get started.

As i mentioned earlier i want to be prepared as much as possible for the training, to have prepared question...so i would like to ask those of you who have experrience to help me and direct me in this matter. I belive that any kind of advise will be helpfull, especially if you can send me some tutorials or something like that.
Also my problem is that i finished power engineering, so i'm not that skilful in robotics, but i'm willing to learn, and i have to learn, because that will be my assignment.

Thank you in advance! :)

Danijel

Pages: [1]