Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - Yetu

#1
How to connect and control Spindle on KRC2ed05, kss5.4 controller via Modbus communication port of Delta C2000 Inverter.
I am having difficulty with this, can anyone with experience share with me? Thank you very much.
#2
Hello. I need help with the flashing light error on the KRC2 cabinet. My KRC2 cabinet has a flashing light error on the KSD1 and KPS-600 drives, the screen shows some errors (I did not save to post here). The supplier's engineer informed that the hard drive has data errors and they sent a Ghost image for me to Ghost the data again. After Ghosting the new data, (The software version has been upgraded from 5.4 to 5.5.) The serial number in the RDC of the machine has been reset to 0. However, this error has not been resolved. In addition, there are some errors after I Ghost the data again (as shown in the attached image below). Unfortunately, the supplier's engineers are currently busy with the exhibition event and do not have time to support me, so I have to post here in the hope of getting help. Thank you very much everyone.