Hi everyone,
I have a set of contours which i've turned to toolpaths using SPL movement command. Between each layer, I've connected using LIN movement. If I used the spl movement across all contours, the step between each layer would be off and imprecise. If I used all LIN movments, I'd need too many points which my robot would not support htat many lines of code. (Ic could use many files but i'm lazy that way, besides, I'd never used SPL and this was a cool opportunity to try it out.
The simulation does not present unreachability or singularity problems, however when I run the simulation, at exactly the step between each layer the PRC component turns red and outputs: 1. Solution exception:Index was out of range. Must be non-negative and less than the size of the collection.
Parameter name: index
This seems to happen only at that point, and all other robot positions do not show any errors. All other slider positions show perfect.
I think I can run this code on our KR150 but just wanted tio understand what's going on?
Pictures and definition attached.
best. Rodrigo.
Mexico City.
I have a set of contours which i've turned to toolpaths using SPL movement command. Between each layer, I've connected using LIN movement. If I used the spl movement across all contours, the step between each layer would be off and imprecise. If I used all LIN movments, I'd need too many points which my robot would not support htat many lines of code. (Ic could use many files but i'm lazy that way, besides, I'd never used SPL and this was a cool opportunity to try it out.
The simulation does not present unreachability or singularity problems, however when I run the simulation, at exactly the step between each layer the PRC component turns red and outputs: 1. Solution exception:Index was out of range. Must be non-negative and less than the size of the collection.
Parameter name: index
This seems to happen only at that point, and all other robot positions do not show any errors. All other slider positions show perfect.
I think I can run this code on our KR150 but just wanted tio understand what's going on?
Pictures and definition attached.
best. Rodrigo.
Mexico City.