Hello Johannes
finally I found a time for it.
basically, I used the WorkVisual for finding which Output that I have.
from this image, I can use $OUT[23] and $OUT[24].
before this step, setting your ip in your pc..and make sure your pc is connecting to cabinet (in my case, I connected to X66 from cabinet).
another image is my current result of test output, and the next step will use Arduino for controlling customised tool. :)
Best,
Yuan
finally I found a time for it.
basically, I used the WorkVisual for finding which Output that I have.
from this image, I can use $OUT[23] and $OUT[24].
before this step, setting your ip in your pc..and make sure your pc is connecting to cabinet (in my case, I connected to X66 from cabinet).
another image is my current result of test output, and the next step will use Arduino for controlling customised tool. :)
Best,
Yuan