Author Topic: Pulsing with Robot  (Read 1823 times)


  • New Forum User
  • *
  • Posts: 0
    • View Profile
Pulsing with Robot
« on: September 02, 2019, 12:27:59 PM »
Hi there,I'm balloon
I am recently new to working with Kuka PRC. I am wanting to weld with the robot and was wondering how I could pulse with the robot. I am hoping to extrude the weld and create an object, so I am assuming I need to figure out how to make the robot pulse. Any ideas would be helpful. Thanks!

Johannes @ Robots in Architecture

  • Lead Developer
  • Administrator
  • Forum User
  • *****
  • Posts: 1064
    • View Profile
    • Robots in Architecture
Re: Pulsing with Robot
« Reply #1 on: September 02, 2019, 05:35:14 PM »

I'm not a welding expert, but you can use the regular KUKA PULSE command that works like that: PULSE($OUT
  • ,state,time)

Just put it into a Custom KRL component, which you then place in the right order.