Pulsing with Robot

Started by limitednaja02, September 02, 2019, 12:27:59 PM

Previous topic - Next topic

limitednaja02

Hi there,I'm balloon
I am recently new to working with Kuka PRC. I am wanting to weld with the robot and was wondering how I could pulse with the robot. I am hoping to extrude the weld and create an object, so I am assuming I need to figure out how to make the robot pulse. Any ideas would be helpful. Thanks!


Johannes @ Robots in Architecture

Hello,

I'm not a welding expert, but you can use the regular KUKA PULSE command that works like that: PULSE($OUT
  • ,state,time)
    Just put it into a Custom KRL component, which you then place in the right order.

    Best,
    Johannes