Digital Output - KUKA | prc

Started by TayebBa, June 11, 2021, 02:07:49 AM

Previous topic - Next topic


Hello  :)
when I use the command "Digital Output - KUKA | prc" in DynamoStudio, an error message is displayed "Warning: Logic.RunCORE operation failed"  :'(  :'(.
is there a problem in Kuka  :o ? What is the solution   :-[?

Johannes @ Robots in Architecture

Have you tried not setting a value for the TOOL input?



June 11, 2021, 07:33:51 PM #2 Last Edit: June 11, 2021, 07:36:20 PM by TayebBa
thank you very much the problem is solved  ;D
in this case I cannot simulate the opening and closing of the gripper  ::)