Author Topic: Can you help me align the base ?  (Read 1340 times)

Johannes @ Robots in Architecture

  • Lead Developer
  • Administrator
  • Forum User
  • *****
  • Posts: 1346
    • View Profile
    • Robots in Architecture
Re: Can you help me align the base ?
« Reply #15 on: May 24, 2022, 08:51:30 PM »
That very much depends on the application. For high-accuracy milling I usually calibrate the XYZ values of a long and a short tool (the higher the difference in length the higher the accuracy) and then use the vector to calculate the right ABC values.
I can send you the code, but to get you started you could also just send me the XYZ values of a short and a long tool and I will send you the ABC values back.

Best,
Johannes