Animating Simulation

Started by singline, August 28, 2017, 04:54:27 PM

Previous topic - Next topic


Is there any practical way to animate the simulation? Say for example you're doing an extrusion and want to see the material with the DIG IO places to make sure its turning on and off in the right places?


Ha ! Sounds familiar :)
I have asked for exactly the same feature.
You can check it here :,465.msg1354.html#msg1354.

Johannes @ Robots in Architecture


Yes, the Analysis component would be the way to go as it gives you all the values, and now also the index of the currently displayed position.
I can give you some pointers if you run into a specific issues.



Thanks for the link Wall-E!

And, as always, you're the best Johannes.