Brick laying

[happytriger2000]

I think I'm used to Mastercam Tool and base setups which is quite easy to do, no need for physical calibration.
Ok, so I have just created a base 2 in KRC1, using tool 2 (gripper).


Here is the problem when I enter those numbers of Base 2, X=1298.01, Y=2.73, Z=593.19, I get this:



A little note on how the Tool 2 was done:




Tool 2 was created  as shown above, my question is does the reference point has to be somewhere near the brick or near where the Base was created when creating tool 2??

[happytriger2000]

After sending you an email I got it working  :)

will upload the video soon.

[happytriger2000]

http://youtu.be/XQnhsgCrJmk

[Johannes @ Robots in Architecture]

Excellent, glad to hear that it's working!

Best,
Johannes @ Robots in Architecture