setup MXA module in PRC _ Query

[vitene4776]

hi，everyone, i'm having trouble with the setup.
The current situation is that i've installed MAX(3.0x,My KSS is 8.5) on the robot and the UPD_Server Example has been successfully run，but it didn't work in PRC.
I've disabled the firewall on the PC. I'm not sure if there is a problem with the MXA settings, can someone help me, do i need to set up Physical IP on Mxa Module，is that my PC IP address or somethingelse, and where can i get the Robot ID?

[Johannes @ Robots in Architecture]

Hello,

You need to take care that the mxA version in KUKA|prc matches with your installed KUKA|prc version. You also need to set the (KLI) IP address of the robot. I believe the default is 192.168.0.2 (which is used in OfficeLite), the KUKA standard is 172.31.1.147. Just use the same IP as in the UDP_Server_Example.

We often make specific builds for our members. As you are not registered as a member in the forum, could you please send me an email (johannes@robotsinarchitecture.org) with your exact mxA version as, ideally from a domain that verifies your affiliation/membership?

Thanks!
Johannes