Hello everyone,
We are looking for a solution in which we use the turn table to always make sure the work layer is parallel to the ground. I have managed to get the angles for E01 working but getting the angles for E02 is the problem..
I have placed the problem in a red group inside the Grasshopper file. Hope someone has a solution.
Spiral curve align.3dm
3D curve.gh
We are looking for a solution in which we use the turn table to always make sure the work layer is parallel to the ground. I have managed to get the angles for E01 working but getting the angles for E02 is the problem..
I have placed the problem in a red group inside the Grasshopper file. Hope someone has a solution.
Spiral curve align.3dm
3D curve.gh