Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - mark.macleod

General Discussion / Re: EOAT KITS FOR 3D PRINTING?
March 13, 2022, 05:14:10 AM
Thanks for the response Johannes.

Definitely just looking to do common FDM extrusion using the robot arm.
I am looking for an actual EOAT kit so I can begin exploring the programming.
I thought that many others would be ahead of me on this one...

I guess it may be DIY instructions that I am looking for...
Any leads there?

General Discussion / EOAT KITS FOR 3D PRINTING?
March 03, 2022, 11:16:26 PM
Looking for any experience (or advice) about sourcing an EOAT kit for 3D Printing.
I have roamed through the Forum and not found this specific thread...

Anyone seen any "off-the-shelf" 3D Printing EOAT "kits" for sale?
The arm used for this purpose could be either of our:
- KUKA LBR iiwa 7 R800
- KUKA KR 6 R700 sixx

If not, how about detailed instructions for a DIY EOAT?
(I have access to quite a few older 3D printers which could be a parts supply for this purpose.)

Any and all comments & ideas welcomed!

FYI Video Links:
Why bother with non-planar 3D Priting?: