Messages

Hello Johannes

How can we align ABC?

Hello Johannes

Sorry for the delay
I followed your advice and Came out, with how to fix ABC later

thanks

Hello

Sorry for the delay

Hello. I want to apologize to you To bother. I was disturbed the device data  because we did not have everything adjusted. We had to change the coordinates because it not worked. I think the tool in the data B and C is not correct B-89.998 and C-179.967 Do you think this is normal. When I entered the real data in kuka prc I got an error because the Tool came up incorrectly. Do you think I should fix the tool again?
and Z + moves upwards.

Thanks for everything

Hello we have created a virtual base in the positive. In reality the robot continued to move in the negative from 0 to -412 mm

Hello, we have used the machine relatively higher than the table Asero Z coordinate is negative

Hello, I have calibrated the machine and also corrected the base but it does not work

thanks

Can you help me align the base ?

Hello I wonder why it closes the 8mm round in the corner when I put in a 4mm cutter and I have a right angle in the drawing thanks