Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - kerber.g

#1
Support / Re: KUKA PRC and Stäubli RX170HP 6-Axis
January 25, 2016, 10:18:59 PM
I imagined that was the case... Thank you! the search for my KUKA continues then.
#2
Support / KUKA PRC and Stäubli RX170HP 6-Axis
January 25, 2016, 09:34:47 PM
Hello Forum, is it possible that the PRC would work with a Stäubli RX170HP 6-Axis? Thanks!
#3
Until I can afford my own kuka Id like to do more than digitally simulate a robots movements...
Are there any 6 axis desktop robot toys that might be able to be controlled by the Kuka prc?
Maybe this one?

http://www.bizoner.com/arduino-6-dof-programmable-clamp-robot-arm-kit-ready-to-use-p-238.html

this ones not 6 axis but maybe could work? http://blog.ufactory.cc/category/robot-arms/

Id really like to play with pick and put operations and just test grasshopper driven movements in general.
Thanks -Ethan
#4
Hello! thanks for all your inspiring work! I wish I could have attended the conference in Michigan and am sad that the next one is 2 years away. I will start learning as much as I can until then however I do not have access to a robot so all I can do is simulate. I am curious where i can find a list of robots that the plug in will work with so that as I keep an eye on the used market I know which machines are viable for this generative approach. Thanks. -Ethan midnightmetalworks.com